Brocade Universal Two-Post Rack Kit Installation Procedure (Supporting VDX 6740T) - Manual (Page 4)

4 of 12 Universal Two-Post Rack Kit Installation Procedure
53-1002943-01
Tool requirements and parts list
The following items are required to install a switch using the universal two-post rack kit:
• Clamps or other means of temporarily supporting the switch in the rack.
• Phillips #2 torque screwdriver
ATTENTION
Use the screws specified for use with the switch. Longer screws can damage the switch.
Ensure that the items listed and illustrated in Figure 1 are included in the kit.
FIGURE 1 Items in the universal two-post rack kit
Installation procedure for flush mounting
NOTE
The illustrations for this procedure show a two-post rack with narrow posts (3- to 5-inch) as an example.
1 Front brackets (2) 5 Screw, 8-32 x 5/16-in., flathead Phillips (16)
2 Rear brackets, 3-5 inch post (2) 6 Screw, 6-32 x 1/4-in., panhead Phillips (8)
3 Rear brackets, 5-6 inch post (2) 7 Screw, 10-32 x 5/8-in., panhead Phillips (8)
4 Screw, 8-32 x 5/16-in., panhead Phillips (8) 8 Retainer nut, 10-32 (8)