Brocade Access Gateway Administrator's Guide (Supporting Fabric OS v7.3.0) - Manual (Page 87)

SAN Configuration with Access Gateway
● Connectivity of multiple devices overview.......................................................................85
● Direct target attachment..................................................................................................86
● Target aggregation..........................................................................................................87
● Access Gateway cascading............................................................................................ 88
● Fabric and Edge switch configuration............................................................................. 90
● Connectivity to Cisco fabrics........................................................................................... 91
● Rejoining Fabric OS switches to a fabric........................................................................ 91
Connectivity of multiple devices overview
This chapter describes how to connect multiple devices to a switch in Access Gateway (AG) mode, and
discusses Edge switch compatibility, target aggregation, direct target attachment, port requirements,
NPIV HBA, and interoperability. Switches in AG mode can connect to third-party fabrics with the
following firmware versions:
• Fabrics operating with M-EOSc v9.6.2 or later and M-EOSn v9.6 or later.
• Cisco fabrics that support standards-based NPIV.
Considerations for connecting multiple devices
Consider the following points when connecting multiple devices to a switch in AG mode:
• AG does not support daisy chaining when two AG devices are connected to each other in a loop
configuration.
• Loop devices and FICON channels/control unit connectivity are not supported.
• When a switch is in AG mode, it can be connected to NPIV-enabled HBAs, or F_Ports that are
NPIV-aware. Access Gateway supports NPIV industry standards per FC-LS-2 v1.4.
Access Gateway Administrator's Guide 85
53-1003126-01