Brocade Fabric OS Encryption Administrator’s Guide Supporting RSA Data Protection Manager (DPM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 267)

Fabric OS Encryption Administrator’s Guide (DPM) 247
53-1002922-01
Encryption group and HA cluster maintenance
6
FIGURE 108 Removing a node from an encryption group
The procedure for removing a node depends on the node’s status within an encryption group. HA
cluster membership and Crypto LUN configurations must be cleared before you can permanently
remove a member node from an encryption group. To remove a node from an encryption group,
complete the following steps:
1. Log in to the group leader as Admin or SecurityAdmin.
2. If the node is part of an HA cluster, you must remove it. To do so, complete the following steps:
a. Remove the node from the HA cluster using the cryptocfg
--
rem
-
haclustermember
command.
b. Clear all CryptoTarget configurations from the member node using the cryptocfg
--
delete
-
container command, or move the container using the cryptocfg
--
move - container
command.
3. Determine the state of the node. Log in to the member node and enter the cryptocfg
--
show
-
groupmember command followed by the node WWN. Provide a slot number if the encryption
engine is a blade.
SecurityAdmin:switch> cryptocfg --show -groupmember \
10:00:00:05:1e:41:99:bc
Node Name: 10:00:00:05:1e:41:99:bc (current node)
State: DEF_NODE_STATE_DISCOVERED
Role: MemberNode