Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) - Manual (Page 18)

Installation will take a few minutes after you click OK.
3. Click Done on the last window (shown in the following figure) to exit the installer.
FIGURE 3 EZSwitchSetup Installer window
On Windows, EZSwitchSetup starts automatically after it is installed. If it does not, refer to
Launching the EZSwitchSetup wizard on page 16 to launch the EZSwitchSetup wizard
manually.
On Linux, follow the procedure in Launching the EZSwitchSetup wizard on page 16 to launch
the EZSwitchSetup wizard.
Launching the EZSwitchSetup wizard
Perform the following, depending on your operating system:
• On Windows: EZSwitchSetup starts automatically after it is installed. If it does not, then from the
Start menu, select Programs > EZSwitchSetup > EZSwitchSetup.
• On Linux: EZSwitchSetup does not start automatically, so you must start it manually.
NOTE
The Linux installation requires root access.
Launching the EZSwitchSetup wizard
16 EZSwitchSetup Administrator’s Guide
53-1003129-01