Brocade Network Advisor SAN + IP User Manual v12.1.0 - Manual (Page 2043)

2004 Brocade Network Advisor SAN + IP User Manual
53-1002949-01
CLI Templates
G
TABLE 31 MCT Cluster Deletion
Feature Description CLI Commands
MCT Delete cluster. no cluster $<CLUSTER_NAME|STRING>
$<CLUSTER_ID|INTEGER>
no vlan $<SESSION_VLAN|INTEGER>
no vlan $<KEEP_ALIVE_VLAN|INTEGER>
TABLE 32 MCT Client Creation
Feature Description CLI Commands
MCT Create a cluster client. cluster $<CLUSTER_NAME|STRING> $<CLUSTER_ID|INTEGER>
client $<CLIENT_NAME|STRING>
rbridge-id $<CLIENT_RBRIDGE_ID|INTEGER>
client-interface ethernet $<CLIENT_PORT|SLOT_PORT>
deploy
TABLE 33 MCT Client Deletion
Feature Description CLI Commands
MCT Delete a cluster client. cluster $<CLUSTER_NAME|STRING> $<CLUSTER_ID|INTEGER>
no client $<CLIENT_NAME|STRING>
TABLE 34 MPLS – Loopback Interface Configuration
Feature Description CLI Commands
MPLS Loopback interface configuration
used for device reachability using
OSPF. It assigns an IP address and
advertises the interface through
OSPF. ! Required for LSP egress address in LSP Manager as well as a
soft interface for IP routing
interface loopback $<LOOPBACK_INTERFACE|INTEGER>
enable
ip ospf area $<OSPF_AREA|INTEGER>
ip address $<LOOPBACK_INTERFACE_IP|STRING>
TABLE 35 MPLS – Core Interface Configuration
Feature Description CLI Commands
MPLS MPLS core interface configuration
such as assigning an IP address and
advertising using OSPF ! Core facing interfaces need IP address for MPLS
! Repeat the following commands for all MPLS core interfaces in
the product
interface ethernet $<CORE_INTERFACE_1|SLOT_PORT>
enable
ip ospf area $<OSPF_AREA|INTEGER>
ip address $<CORE_INTERFACE_1_IP|STRING>
router mpls
mpls-interface ethernet $<CORE_INTERFACE_1|SLOT_PORT>