AeroGarden Classic - Manual

Transfer plants to Grow Surface:
Unplug AeroGarden; remove Bowl from Base. Take Bowl to sink or work surface that
can get wet.
Remove Grow Surface from Bowl and place on work surface.
Pour nutrient-rich water from old Bowl to new Bowl. Discard old Bowl.
Transfer plants to Grow Surface:
Unplug AeroGarden; remove Bowl from Base. Take Bowl to sink or work surface that
can get wet.
Remove Grow Surface from Bowl and place on work surface.
Pour nutrient-rich water from old Bowl to new Bowl. Discard old Bowl.
- OR - - OR -
REPLACING AEROGARDEN BOWL
(For AeroGarden Classic, AeroGarden Deluxe, AeroGarden PRO 100 and AeroGarden PRO 200 )
REPLACING AEROGARDEN BOWL
(For AeroGarden Classic, AeroGarden Deluxe, AeroGarden PRO 100 and AeroGarden PRO 200 )
© 2008 AeroGrow International, Inc.
300419AA 6/3/08
© 2008 AeroGrow International, Inc.
300419AA 6/3/08
1 1
2 2
3 3
For older plants with thick roots:
Before lifting Pods out of holes, gently untangle roots from each Pod. Do not be
concerned if you tear a few roots.
Gently lift Pods out of each Grow Surface Opening –you may need a spoon or pen to help
get stubborn Pods loose.
Guide the roots out of each hole with one hand pulling on Pod and the other pushing
roots from below.
Guide the roots into each corresponding Grow Surface Opening using a similar method.
Be sure all roots are hanging down through openings. Discard old Grow Surface.
Place new Grow Surface on new Bowl and check that roots are in the water.
Return Bowl to Base and plug in AeroGarden.
For older plants with thick roots:
Before lifting Pods out of holes, gently untangle roots from each Pod. Do not be
concerned if you tear a few roots.
Gently lift Pods out of each Grow Surface Opening –you may need a spoon or pen to help
get stubborn Pods loose.
Guide the roots out of each hole with one hand pulling on Pod and the other pushing
roots from below.
Guide the roots into each corresponding Grow Surface Opening using a similar method.
Be sure all roots are hanging down through openings. Discard old Grow Surface.
Place new Grow Surface on new Bowl and check that roots are in the water.
Return Bowl to Base and plug in AeroGarden.
1 1
2 2
3 3
5 5
3 3
4 4
6 6
4 4
For young plants with small roots:
Gently lift Pods out of each Grow Surface Opening –you may need a spoon or pen to help
get stubborn Pods loose.
Guide the roots into each corresponding Grow Surface Opening. Be sure all roots are
hanging down through hole. Discard old Grow Surface.
Place new Grow Surface on new Bowl and check that roots are in water.
Return Bowl to Base and plug in AeroGarden.
For young plants with small roots:
Gently lift Pods out of each Grow Surface Opening –you may need a spoon or pen to help
get stubborn Pods loose.
Guide the roots into each corresponding Grow Surface Opening. Be sure all roots are
hanging down through hole. Discard old Grow Surface.
Place new Grow Surface on new Bowl and check that roots are in water.
Return Bowl to Base and plug in AeroGarden.
1 1
2 2