DataComm 45-0028-WH Recessed Pro-Power Kit - Manual

Use the Recessed Pro-Power Kit with Duplex Receptacle and Straight Blade Inlet to install power and low voltage cables behind your flat panel TV,
amplifier or other audio and video devices to your equipment room or at the location of your head end equipment (see Figures 1 & 2).
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
Instruction / Installation Sheet
DataComm Electronics 45-0024-WH Recessed Pro-Power Kit with Duplex Receptacle and Straight Blade Inlet
Parts Included:
1.
Recessed Low Voltage Mid-Size Plate with Duplex Receptacle
2. Recessed Low Voltage Cable Plate with Straight Blade Inlet
3. Two (2) Electrical Outlet Boxes
Four (4) Screws per Outlet Box
4. 15 Amp/125 Volt Tamper Resistant Duplex Receptacle
5. Three (3) Wire Nuts
6. 6ft. 16/2 with Ground Cord Set with 360 o Rotating Head
Tools Needed:
1. Drywall
Saw
2. 6 Ft. Tape Measure
3. Pencil
4. Screwdriver
Figure 1 – Front View Figure 2 – Back View
IMPORTANT INSTRUCTIONS:
 Use the local electrical code approved installation when installing this product.
 The electrical parts in this kit are designed to be used only as a kit and none of these electrical parts are designed to be used individually.
 This product is not designed to be part of your home or a commercial building’s electrical wiring system.
 This installation is only energized (electrically active) when the supplied 6 ft. cord is plugged into the recessed straight blade inlet located on the
recessed low voltage cable plate and the straight blade end of the 6 ft. cord is plugged into either your surge protector or wall receptacle.
If you are not familiar with home wiring systems, please call a qualified electrician to install this product.
IMPORTANT INSTRUCTIONS:
This product is designed for retrofit work only because the electrical outlet box cannot be attached to a stud.
Installation Instructions for Retrofit Only:
Select the location of your flat panel TV mounting bracket. Now select the location for both cable plates for the Recessed Pro- Power Kit with Duplex
Receptacle and Straight Blade Inlet.
Page 1 of 4 9/21/12