DataComm 45-0004 Reverse Nose Décor Insert User Manual

DataComm For Home

Advertising
background image

DataComm Electronics, Inc.

6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205

www.DataCommElectronics.com

Tools Needed

Philips Head Screw Driver

Installation
1. Before installing the Reverse Nose Décor Insert, you must first install a low

voltage mounting bracket (sold separately) into the wall. Refer to the instructions on

the low voltage mounting bracket for assistance.

2. Run low voltage A/V cables through the opening in the low voltage mounting bracket,

and then through the opening of the Décor Insert.

3. Place the Décor Insert against the low voltage mounting bracket. Using the two (2)

included screws, screw the Décor Insert into place on the low-voltage mounting

bracket.

4. To give your installation a finished look, install a décor wallplate (sold separately) over

the Décor Insert.

Instruction / Installation Sheet

Reverse Nose Décor Insert

Part # 45-0004

Use the Reverse Nose Décor Insert to install low

voltage cables behind your HDTV, amplifier or

other audio video devices. The Reverse Nose

Décor Insert is designed to be installed onto a low

voltage mounting bracket (sold separately) that is

installed into the wall.

• This product is designed for use with low

voltage cables ONLY.

• DO NOT run or pull a TV cord or other

electrical cords inside the wall.

• It is a violation of the National Electric Code

(NEC) to run power cords or extension

cords behind the wall.

This product is patent protected by U.S. Patent numbers D553475, D554475

and 7,390,964 B2. RoHS Compliant.

Caution:

• Never install low voltage wiring during lighting storms.

• Never touch un-insulated wires or terminals unless the wire has been disconnected at

its network interface.

• Use caution when installing or modifying data or telecommunication lines.

• DO NOT alter, change, or disconnect existing telecommunication wires if you are

unsure of their purpose or function.

• It is NOT recommended to install this product in close proximity to an electrical service

panel to prevent interference from electrical current.
Important Instructions:

• Read and understand all instructions.

• Do not use this product near water, for example near bath tub, wash bowl, kitchen,

sink, or laundry tub, in a wet basement, or near a swimming pool.

• SAVE THESE INSTRUCTIONS.

Advertising