Davey ECOPURE CARTRIDGE FILTERS 50/75/100/150sqft - Manual (Page 6)

FILTER CARE
The Monarch Series Cartridge Filter is the heart of the pool
equipment installation. Proper care and maintenance will add many
years of service and enjoyment to your pool. Keep the exterior of the
filter clean using a mild detergent and water.
TROUBLE SHOOTING
Reduced flow of water to the pool generally indicates the filter is
ready to be cleaned. Check the filter pressure gauge. (See section
on ‘Filter Operation’). If cartridge cleaning is required, perform the
steps described earlier in ‘Cartridge Cleaning Procedure’. If there is
still reduced flow after cleaning, check for blocked or plugged lines
which could restrict the volume of water entering the pool.
In the event of installation or operation difficulties with your
Monarch Series Filtration Equipment, contact the supplier from
whom the filter was purchased or contact the Davey Customer
Service Centre for assistance.
REMOVAL OF THE FILTER
Should it be necessary to remove the filter, the following procedure
should be followed :
1. Switch off the pump and remove the plug from the power
point.
2. Open the air bleed valve on the filter lid.
3. Close isolating valves where fitted.
4. Remove: – piping connection to the pump
– piping connection to the pool return
5. Remove filter.
Dirt & debris returning to your pool may indicate the pressure
relief valve has been activated. Remove & clean the element
and check that valve inside base of filter is free of foreign
matter.
• Page 6 •
Danger HIGH PRESSURE. Relieve internal pressure before
adjusting locking rings or opening filter.