Elitegroup MB40II ID 6 - Manual (Page 10)

4
 The minimum specifications for the flexible cord are
No. 18 AWG, (2) Type SPT-2, and (3) 2-conductor.
B. For Japan:
 All components of the cord set must bear a “PSE”
mark and in accordance with the Japanese Dentori
Law.
 The minimum specifications for the flexible cord
are .75m ㎡ conductors, (2) Type VCTR or VCTFK,
and (3) 2-conductor.
 The cord set must have minimum rated current
capacity of 7 A.
 The attachment plug must be a two-pole, grounded
type with a Japanese Industrial Standard C8303 (15
A, 125 VAC) configuration.
C. For Other Countries:
 The cord set fittings must bear the certification mark
of the agency responsible for evaluation in a specific
country.
 The flexible cord must be of a HAR (harmonized)
type H03VVH2-F.
 The cord set must have a current capacity of a least
2.5 Amperes and voltage rating of 125 or 250 Vac.
MODEL MB40IIX (x=0~9) IS DESIGNED
TO USE WITH THE FLLOWING AC ADAPTER MODEL ONLY
65W ADP:
BAT MB403 LI CEL 3S2P LG-L3 4.4AH S1 D - CEL
BAT MB403 LI GLW 3S2P LG-L3 4.4AH S1 D - GLW
BAT MB403 LI SMP 3S2P BAK 4.4AH S1 D - SMP
17. When using your telephone equipment, basic safety
precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons. These precautions
include the following:
Do not use this product near water, for example, near a
bathtub, washbowl, kitchen sink or laundry tub, in a wet
basement or near a swimming pool.
Avoid using a telephone (other than a cordless type)
during an electrical storm. There may be a remote risk of
electric shock from lightning.