Elitegroup 755II1 v.4 - Manual (Page 5)

■ chapter 4 upgrading your computer
4-5
Remove the metal case.
7. Re-attach the metal cover to the new hard drive and
tighten 4 Screw C’s. Note the green PC board of the hard disk
drive is facing against the metal case.
8. Push the HDD assembly into the HDD bay until the
connectors are firmly joined.
9. Re-attach and tighten Screw B. (If the HDD assembly is
not fully inserted into the bay, the screw and its hole will not line
up.)
10. Replace the System Device Cover and 3 Screw A’s.
Congratulations! You have now completed the hard drive
upgrade. When you boot up the PC, you may need to create a
primary HDD partition and reformat the new drive and re-install
O/S, drivers, and all the necessary applications.