Elitegroup E07EI1 - Manual (Page 43)

37
Your computer has been tested with a
wide range of DIMM on the market. However, not all memory
modules are compatible. Check with your system vendor for a
list of compatible DIMM for your computer.
Upgrading the Mass-Data-Storage Device
To upgrade the mass-data-storage capacity, you can either replace
the existing M-System flash storage module with one that has a
higher capacity, or instead, replace it with the 1.8 inch P-ATA-type
hard disk drive module. You need to obtain the optional upgrade
kits from your dealer, as this type of module is not commonly
available.
Be sure to make a backup copy of all your data before attempting
this operation.
The upgrade is a delicate
process. Please observe the following instructions carefully
or have a qualified technician install it for you. Damages due
to mishandling of this procedure are NOT covered by the
manufacturer’s warranty.
Apply care when handling the hard disk.
• Do not drop or apply any shock.
• Do not press on the cover.
• Do not touch the connector with your fingertips.
• Mishandling of the hard drive can result in permanent loss of
data. Make a backup copy of the content within the drive
before you remove it.
Upgrading the M-System Flash Storage Module
To upgrade the flash storage module, do the following:
1.
Follow the first four steps in the previous section,
Upgrading the System Memory Module
, to access the
Flash Storage Module.
2.
Locate and remove one Screw A.