Elitegroup MD120 (V1.0) - Manual (Page 28)

22
Using BIOS
Press <Esc> to return to the main menu setting page.
Resume By PCI/PCI-E/Lan PME (Disabled)
These items specify whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or component is
detected.
Resume By USB (S3) (Disabled)
This item allows you to enable/disable the USB device wakeup function from S3/S4
mode.
Resume on RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system’s RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm.
You must use an ATX power supply in order to use this feature.
Power Management Setup
This page sets up some parameters for system power management operation.
Select the ACPI
state used for
System Suspend.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type (S3)
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.
Help Item
mnlk : Move F10: Save ESC: Exit Enter : Select +/-/: Value
F9: Load Default Settings F1: General Help
ACPI Suspend Type S3
Resume By PCI/PCI-E/Lan PME Disabled
Resume By USB (S3) Disabled
Resume on RTC Alarm Disabled
EUP Support Enabled
EUP Support (Enabled)
When enabled, system can not resume by some devices (PCI/PCIE/PME/Ring/RTC,
etc) at S5 state. You can use this item to save power.