Elitegroup EZ-Buddie2 D21 I4-3 Install v.3 - Manual (Page 12)

12
D. We strongly suggest that remove the
ODD Bezel from the Optical Device
Disk
E. Screw the drive to the left and right
sides with two screws each.
.
D. Plug the one end of the gray
flat-cable into the white IDE by the
direction of the foolproof design.
E. Plug the other end of the gray
flat-cable into the driver by the
direction of the foolproof design.
F. Plug the power cord with the red
line on the inside.
The Installation of the PC case
Installing the PC case
A. Lay the cover on the chassis leaving a 5cm clearance
from the front panel, and then push it forward to lock the
cover.
B. Screw the cover with three screws and finish with the
hardware installation.
This clearance is about
5cm. A longer or shorter
clearance may causes
inconvenience in
installation.