Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 11)

Part No. 4801-5072 Rev 9-08 SideWall Curtain Page 11
8.6 Fasten Sidewall Curtain Systems to Boards
After completing Section 8.1 through Section 8.5, the system will consist of all vertical members
and all bottom channels fastened together as an assembly. The assembly should have freedom of
movement since screws have not been tightened.
1. Refer
to Fig. 8. Use a level to make sure that sidewall systems are level.
Make any required adjustments.
2.
Check that vertical members at the left end and right end of the opening are plumb.
Make any required adjustments.
3. Tighten all screws holding assembly to 2"x 6" boards.
4.
Attach self-drilling lag screws through all remaining drill holes of vertical members and
bottom channels to securely fasten the assembly to 2"x 6" boards.
Figure 8
Make sure systems are level.
Make sure that vertical members
are plumb. To determine this,
check that left track and right
track are plumb.
After checking that systems are
plumb and level, fasten systems to
the 2"x 6" boards by tightening self-
drilling lag screws.
Install all remaining screws through
screw holes of right track, center
tracks, left track, and bottom
channels.