Figure 4: install bracket to cone – Hired-Hand Mega Flow SlantWall Fans: METAL CONE Installation Rev 9-05 User Manual
Page 2
HIRED-HAND MFG., INC.
• 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5128 Rev 9-05 Page
2
of
4
48"/52" Cone/Slantwall Fan Bracket (0404-5640
)
52" Cone
/Slantwall
48" Cone
/Slantwall
4. Four corner support brackets are supplied as flat perforated
metal sheets with flanges. Bend each sheet along perforations
as shown in Figure 2 to form support brackets.
5. Figure 3 shows the three different corner support brackets
after bending and the correct attachment holes for mounting
to the specific cone size.
6. Install three corner brackets to joints of panel assembly as
shown in Figure 4. The 36", 48" and 52" Corner Support
Brackets attach to the two holes in the cone nearest the small
cone opening with 1/4" bolts and nuts. To install bolt, insert
bolt through hole of bracket, then through hole of flange, and
into hole of tab as shown in Figure 4. NOTE: Start nuts
onto bolts. Leave nuts and bolts loose until cone is installed
in unit.
Flat sheet
Bend along
perforations
Support ready
for installation
Figure 2: Form Support Brackets
Figure 3: Support Bracket
Mounting Holes
36" Cone Fan Bracket (0404-4834)
Holes to Mount Bracket
36" Slantwall Fan Bracket (0404-7218)
Holes to Mount Bracket
Guard Mounting Hole
Tab fits to side of
flange opposite
bracket
Figure 4: Install Bracket to Cone
Flange