Hired-Hand Polar Cool: Pump & Float Replacement - Manual

ROLLSEAL, INC • 1751 Co Rd 68 • Bremen, AL 35033 • Phone 256-287-7000 • Fax 256-287-7010
R
Tools Required
Drill with 3/16” drill bit Adjustable wrench
Phillips Head Screwdriver
Parts Required (Shipped Separately)
Quantity Item Quantity Item
1 Motor/Pump with Male Fitting 1 Mounting Bracket
2 Adjustable Cable Clamps 1 17 “ Section of Hose
2 Mounting Bolts and Nuts
Directions
1. Remove electrical power from the PolarCool.
2. Identify the parts location as shown in Figure 1.
3. Disconnect 110 Volt power lead at the junction
box that leads to the old pump.
4. Remove old pump, bracket and hose connected
to incoming water supply. See Figure 2.
5. Remove the old float assembly from the
cabinet wall. See Figure 2.
6. Assemble the float valve lock nut and hose
fitting to the bracket as shown in Figure 3.
7. Attach the hose to the float assembly as seen
in Figure 4.
8. Attach the float assembly to the cabinet wall
as shown in Figure 5 with 1/4”x20x1/2” bolts
and nuts.
PolarCool Pump & Float Replacement
Manual Part # 4801-5314
Junction
Box
Old
Pump
Float
Assembly
Figure 1
Hose
Fitting
Bracket
Old Pump
Old Float
Pump
Mounting
Bracket
Figure 2
Hose
Pump
Mounting
Bracket
Old Pump
Old Float
Bracket
Hose
Fitting
Figure 3
Float Arm Lock Nut