APC Network Management Card AP9617 - Manual (Page 16)

Quick Configuration
Control console
After you log on at the control console, as described in either
“Local access to the control console” on page 14 or “Remote
access to the control console” on page 15:
1. Choose Network from the Control Console menu.
2. Choose
TCP/IP from the Network menu.
3. If necessary, change the Boot Mode setting to Manual.
4. Set the System IP , Subnet Mask and Default Gateway
address values.
5. Press C TRL -C to exit to the Control Console menu.
6. Log out (option 4 in the Control Console menu) to have
the changes take effect.
Note
If you disconnected a cable during the
procedure described in “Local access to the
control console” on page 14, reconnect that
cable and restart the associated service.