Johnson Level & Tool Mfg. 40-6200 - Manual

PowerLine™ Magnetic-Laser “Sheave Alignment System”
Instructions
The PowerLine™ Magnetic-Laser Sheave Alignment System laser aligns belts, pulleys, sheaves,
sprockets, gear trains, rollers, platforms, conveyors, and other plant equipment. Its purpose is to replace
often times inaccurate and time-consuming straightedge and string alignment methods currently in use.
Compared to these older methods, PowerLine is easier, faster, and more accurate. With PowerLine™, you
will greatly reduce downtime and belt failures.
Component Descriptions
The PowerLine™ Magnetic-Laser Sheave Alignment System includes a laser line emitter, three grooved
targets, and 2 belt tension testers. All components are especially rugged for long life and are shipped in a
sturdy storage case.
Laser Line Emitter:
Its bottom machined surface mounts magnetically to the machined face of sheave, gear, etc. It projects a
1/16” thick laser reference line over a wide angle. The projected reference line is parallel to the machined
bottom surface and offset from it by 0.312”.
Warning and Certification Label
Bottom Surface is on Back Side
Level Vial Product Identification Battery Cap
Label On/Off Switch
Laser Safety:
Caution- Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
The PowerLine™ emitter uses a laser diode with a maximum output power of less than <1 milliwatt
@ 635 nm. The laser classification is a Class II with only minor precautions required. Never stare
directly into laser transmitter or aim laser into someone’s eyes. PowerLine™ complies with 21CFR
parts 1040.10 and 1040.11.