Kushlan Products 350DD Epoxy - Manual (Page 2)

•After referring to the operation manual, if assistance is still needed, please consult our web Site at
www.kushlanproducts.com
• From our web site you may e-mail us directly If assistance is still required, please call our customer service
department at 1-800-469-4178
Safety Alert Symbol: This safety alert symbol is used to attract your attention!
• Personal Safety is involved when you see this symbol, Pay extra attention, become alert-be sure to heed it’s message.
Failure to do so may lead to serious personal injury or damage may occur.
• Warnings and safety instruction: If these warnings and safety instructions are not read and carefully followed, serious
personal injury could occur.
WARNINGS
1. Do not use, start, or attempt to operate this machine until all of the instructions have been read and fully understood.
2. Never allow anyone to operate this machine unless the person is well acquainted with these rules of safe operation.
3. Never operate this machine without all guards in place and firmly attached to the machine.
4. Make certain that the mixing drum is clear of obstructions and stand clear of the machine with out all guards in place and firmly attached to the machine.
5. When cleaning, lubricating, or adjusting the mixer, disconnect the power plug.
6. Keep all people (except operator) a minimum of five (5) feet away from the machine during operation.
7. Always make certain that the mixer is connected to a properly grounded electric circuit to protect the operator from possible electric shock.
8. Do not start the engine if the drum is Fully loaded
9. Do not overload the mixer
10. Never attempt to move the mixer while the engine is on.
SHOULD YOU REQUIRE ANY
SET-UP OR OPERATING ASSISTANCE WITH YOUR PRODUCT,
DO NOT RETURN TO ORIGINAL PLACE OF PURCHASE
SAFETY INSTRUCTIONS
For the safety of yourself and others around you, it is extremely important that you observe the following notes.
1. Keep hands and clothing away from moving parts at all times.
2. Do not operate this machine under the influence of alcohol or while taking medication that impairs the senses or reactions.
3. Make certain that the work area around the machine is clear of debris and obstructions.
4. Keep all unauthorized and untrained people away from the machine at all times.
5. Never let the mixer run unattended even for a brief moment.
6. Turn off the engine when you leave the machine.
7. Only use or operate the mixer on level ground to prevent the mixer from tipping over.
8. Do not overreach while working with the mixer. Keep proper Footing and balance at all times when loading or unloading the mixer.
9. Never allow children or inexperienced operators to operate or repair the mixer.
10. Use only factory authorized parts for replacement
11. Keep these operation instructions with the machine at all times
12. Always wear safety glasses and safety shoes when operating and moving equipment
13. Safety decals – replace missing damaged safety decals.
Mixer Instructions
A. LUBRICATION: There are grease fittings on all models. Apply any type of EP grease until grease begins to come out of the
bushings. LUBRICATE ALL FITTINGS BEFORE EACH USE
B. GEARBOX MOTOR: Mixer shipped with lubricate/oil in gearbox. Change lubricate/oil every 200 hours. Use Synthetic
Mobile 1 LS 75W-90 oil.
C. GENERAL: Check all screws for tightness before each use.
D. CONCRETE MIXING: Do not insert sharp objects into the plastic mixing drum. Doing so will damage the drum.
E. CLEANING: Do not spray water on or into the motor. Thorough cleaning of the mixer after each use is recom
mended and will add to the service life.
2