Kushlan Products 600 Gas - Manual (Page 7)

Assembly Instruction
Step 1
Wheel Assembly
Step 2
With the long end of wheel hub facing
out assemble.
Step 3
Install Wheels as shown, pushing axle rod
end out and the other end into the frame.
Step 4
Put washers on the axle, then fix R clips
into holes.
Step 5
Take apart and remove all bolts from
drum plate
Step 6
Put the shaft through the hole in the
drum. Turn drum until the holes line
up. Put in 3/8 x 1-1/4’’ whizlock screw.
Then install blade.
Note: Do NOT tighten until all screw
are in place.
Step 7
Slide drum on frame. Then install
pinion housing.Line up front of pinion
with front large gear
(Note: Do not position pinion to far
forward, so gear will dig into drum.)
Step 8
Install Gas Engine with 2 5/16 * 1’’ bolts
as shown. Do not over tighten belt about
1/4’’deflection.
Step 9
Install ring gear guard with 3/4” hex screw.
Step 10
Install back engine cover with 5/16” x 3/4”
whizlock screw
Step 11
Slide handle in place lining up the hole
in the handle and the housing. Slide
the pin through the holes.
Step 12
Slide the pin through the holes. Soak Grips
in boiling water for 1 minute to soften the
heavy duty rubber.
7