Lincoln Electric IM669 RED-D-ARC DC-600 - Manual (Page 10)

STACKING
Three DC-600 machines can be stacked.
DO NOT stack more than three machines in one
grouping.
DO NOT stack the DC-600 on another type of
machine.
Follow these guidelines when stacking:
1. Select a firm, level surface capable of sup-
porting the total weight of up to three
machines (1570 pounds/712 kilograms).
2. Set the bottom machine in place.
3. Stack the second machine on top of it by
aligning the two holes in the base rails of the
second machine with the two pins on top front
of the bottom machine.
4. Repeat process for third machine.
NOTE: The machines must be stacked with the Case
Front of each machine flush with each other. See
Figure A.1.
FIGURE A.1 - Stacking DC-600 machines
TILTING
The DC-600 must be placed on a stable, level surface
so it will not topple over.
A-2 INSTALLATION A-2
Read entire Installation Section before installing
the DC-600.
SAFETY PRECAUTIONS
ELECTRIC SHOCK CAN KILL.
• Only qualified personnel should
install this machine.
• Turn the input power OFF at the
disconnect switch or fuse box
before working on the equipment.
• Do not touch electrically hot parts.
• Always connect the IDEALARC DC-600 grounding
terminal to a good electrical earth ground.
• Set the DC-600 Power ON/OFF PUSH BUTTON to
the OFF position when connecting power cord to
input power.
-----------------------------------------------------------------------------------------
SELECT PROPER LOCATION
Place the welder where clean cooling air can freely
circulate in through the front louvers and out through
the rear louvers. Dirt, dust or any foreign material that
can be drawn into the welder should be kept at a mini-
mum. Failure to observe these precautions can result
in excessive operating temperatures and nuisance
shut-downs.
WARNING
DC-600 RED-D-ARC
FALLING EQUIPMENT can cause
injury.
• Do not lift this machine using lift bale if
it is equipped with a heavy accessory
such as trailer or gas cylinder.
• Lift only with equipment of adequate lifting capacity.
• Be sure machine is stable when lifting.
• Do not stack more than three high.
• Do not stack the DC-600 on top of any other
machine.
---------------------------------------------------------------------
WARNING
STACKING HOLE
STACKING PINS