Lincoln Electric IM996 CLASSIC 300 D KUBOTA - Manual (Page 15)

B-3 OPERATION B-3
CLASSIC® 300D KUBOTA
IDLER OPERATION
Start the engine with the “Idler” switch in the “High”
position. Allow it to run at high idle speed for several
minutes to warm the engine. See Specifications for
operating speeds.
The idler is controlled by the “Idler” toggle switch on
the welder control panel. The switch has two posi-
tions as follows:
1. In the “High” position, the engine control unit
increases the engine to high idle speed.
2. In the “Auto” / position, the idler oper-
ates as follows:
a. When welding or drawing power for lights or tools
(approximately 100 watts minimum) from the recep-
tacles, the engine operates at high idle speed.
b. When welding ceases or the power load is turned
off, a preset time delay of about 15 seconds starts.
This time delay cannot be adjusted.
c. If the welding or power load is not re-started before
the end of the time delay, the engine control unit
reduces the engine to low idle speed.
AUXILIARY POWER
Start the engine and set the “IDLER” control switch to
the “High Idle” mode. Voltage is now correct at the
receptacles for auxiliary power. This must be done
before a tripped GFCI can be reset properly. See the
MAINTENANCE section for detailed information on
testing and resetting the GFCI.
CLASSIC® 300D WITH KUBOTA V2403M DIESEL ENGINE
TYPICAL FUEL CONSUMPTION DATA
Low Idle (1400 RPM)-No Load
High Idle (1800 RPM)-No Load
3,000 Watts
250 Amps @ 30 Volts
300 Amps @ 32 Volts
0.36 gal/hr ( 1.37 ltrs/hr)
0.49 gal/hr ( 1.86 ltrs/hr)
0.66 gal/hr ( 2.49 ltrs/hr )
1.07 gal/hr ( 4.05 ltrs/hr)
1.31 gal/hr ( 4.96 ltrs/hr)
The AC auxiliary power, supplied as a standard, has a
rating of 3.0 kVA of 115/230 VAC (60 hertz).
With the 3.0 KVA, 115/230 VAC auxiliary power, one
120V duplex protected by GFCI and one 230V duplex,
grounding type receptacle with 2 pole, 15 amp circuit
breaker.
The rating of 3.0 KVA permits a maximum continuous
current of 13 amps to be drawn from the 230 volt
duplex receptacle. 15 amps can be drawn from the
120 volt duplex receptacle. The total combined load of
all receptacles is not to exceed 3.0 KVA.
An optional power plug kit is available. When this kit is
specified, the customer is supplied with a plug for
each receptacle.
When the High Speed Adjustment knob is in the MIN
position, the frequency of the AC auxiliary output may
be reduced to approximately 55 Hertz. It is recom-
mended that the High Idle Speed Adjustment knob
should be in the MAX position when using the AC
auxiliary output.