Lincoln Electric IM544 Commander 400 - Manual (Page 41)

F-9 DIAGRAMS F-9
COMMANDER 400
CONNECTION DIAGRAM:
Keep guards in place. Keep away from moving parts. Only qualified personnel should install,use or service this equipment.
4
41
2
N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
TO WORK
TO WIRE FEED UNIT ELECTRODE CABLE
ADAPTER PLUG
K867 UNIVERSAL
COMMANDER 400 STICK & WIRE TO K867 ADAPTER CONNECTION DIAGRAM
75
115 VAC
76 77 21
GND
32 31
ELECTRODE
TO WORK
TO K867
MIN. 10K
N.C. INSULATE EACH UNUSED LEAD INDIVIDUALLY.
RELAY TO CLOSE LEADS 2 & 4.
N.D. FOR WIRE FEEDERS THAT RETURN A SIGNAL FOR WELDING OUTPUT, USE ISOLATION N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY.
14 PIN AMPHENOL
POWER SOURCE FRAME CONNECTION
Do not operate with panels open.
WIRE FEEDER VOLTMETER CONNECTION
REMOTE OUTPUT CONTROL
CONNECTS TO (WORK TERMINAL) OF POWER SOURCE
TO WIRE FEEDER
CAUTION : THE ENGINE WELDER OPERATING MANUAL. AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
N.E. REFER TO POWER SOURCE INSTRUCTION MANUAL FOR MAXIMUM AUXILIARY CURRENT DRAW.
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
4 2
S22916
42
WARNING
Do not touch electrically live parts. before servicing. Disconnect NEGATIVE (-) BATTERY LEAD
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
82
SPARE
81
N.D.
CONNECT TOGETHER FOR WELDING OUTPUT NOT USED ON COMMANDER 400 POWER SOURCES NOT USED ON COMMANDER 400 POWER SOURCES
N.C.
N.E.
N.C.
6-12-98