Lincoln Electric IM465 INVERTEC DC TIG STARTER - Manual (Page 18)

D-1 MAINTENANCE D-1
INVERTEC DC TIG STARTER
Routine Maintenance
1. Every 6 months or so the machine should be
cleaned with a low pressure airstream. Keeping the
machine clean will result in cooler operation and
higher reliability.
2. Examine the sheet metal case for dents or break-
age. Repair the case as required. Keep the case in
good condition to ensure that high voltage parts are
protected and correct spacings are maintained. All
external sheet metal screws must be in place to
ensure case strength and electrical ground continu-
ity.
Periodic Maintenance
No scheduled periodic maintenance is required for
the DC Tig Starter Kit.
MAINTENANCE
ELECTRIC SHOCK can kill.
• Only qualified persons should install,
use or service this equipment.
• Turn off the input power to the Welding
Power Source using the disconnect
switch at the fuse box before connecting the DC Tig
Starter to the power source, or the Remote Control,
Amptrol or adapter to the DC Tig Starter.
• Welding cable must be sized for current and duty
cycle of application.
---------------------------------------------------------------------
WARNING