Lincoln Electric IM554 K283 DIGITAL WIRE SPEED METER - Manual (Page 2)

To measure wire speed feed on the LN-22 and LN-23P
with a S16001-A or S16001-B wire feed cable, push
the sliding tube up on the cable so meter pickup shaft
can be placed on the wire from the wire reel side.
Check that the sliding tube does not rub on the pickup
shaft.
For maximum life, the wire speed feed meter should be
removed from the wire after wire speed has been
determined. Leaving the meter on the electrode con-
tinuously can lead to reduced guide life and expose the
meter to mechanical abuse.
A flashing “B” indicates batteries are low and they
should be replaced with four AA alkaline batteries. If
there is not display and if temperature is below 32ºF
(0ºC), warm up unit until display returns. Be certain
that batteries make a good electrical connection with
battery terminals and spring contacts.
TROUBLESHOOTING
PROBLEMS
PROBLEMS
(SYMPTOMS)
SOLUTION RECOMMENDED
COURSE OF ACTION
1. Flashing “B” (or total Display)
2. No Display
1. Replace batteries.
2. a. Check batteries.
b. If temperature is below 32
o
(0
o
C), warm up unit until
display returns.
c. Be certain that batteries make
a good electrical connection
with battery terminals and that
batteries make good contact
with spring contacts inside
meter housing.
Contact your Local Lincoln Authorized
Field Service Facility for technical
troubleshooting assistance.
Date of Purchase:
Serial Number:
Code Number:
Model:
Where Purchased:
• Sales and Service through Subsidiaries and Distributors Worldwide •
Cleveland, Ohio 44117-1199 U.S.A. TEL: 216.481.8100 FAX: 216.486.1751 WEB SITE: www.lincolnelectric.com
• World's Leader in Welding and Cutting Products •