Lincoln Electric IM626 Mobiflex 200-M Lamp Kit - Manual (Page 11)

A-4 INSTALLATION
LAMP OPTIONS FOR MOBIFLEX 200-M
A-4
INSTALLING THE 13 FT. CONNECTING CABLE
Roll back the rubber seals and pull back the hose at
each joint to allow access to the arm mechanism.
Route the 13 ft. connecting cable through the four
cable holders in the arm (Fig. 6, Points D). Leave
plenty of slack at each hinge to allow for the full range
of movement of the arm. Secure the cable in the
cable holders (Fig. 6, Inset). Exit the arm through the
cable hole in the rotating hinge; use a knife to cut a
small X-pattern in the grommet and push the cable
through.
Use the supplied wire ties to secure the cable as
shown in Fig. 7.
Reseal all hose joint connections with the rubber
seals.
L=min. 22"
(550 mm)
Fig. 7
D D
4x
A B A
C A
D
D
Fig. 6