Lincoln Electric IM751 POWER-ARC 4000 - Manual (Page 32)

C-1 ACCESSORIES C-1
OPTIONS/ACCESSORIES
LINCOLN ELECTRIC ACCESSORIES
The following options/accessories are available for
your POWER-ARC 4000 from your local Lincoln
Distributor.
Accessory Set (K875) – Includes the following:
• Twenty feet (6.1 meters) of #6 AWG electrode
cable
• Fifteen feet (4.6 meters) of #6 work cable
• Headshield with No. 10 filter
• Work clamp
• Insulated electrode holder
• Sample electrodes
The cables are rated at 150 amps, 40% duty cycle.
Power Plug Kit (K802U) – Provides three plugs, two
for the 120 volt duplex receptacle and one for the 240
volt receptacle.
GFCI Receptacle Kit (K896-3) - Includes one UL
approved 115 volt ground fault circuit interrupter
duplex type receptacle with cover and installation
instructions. Replaces the factory installed 115 volt
duplex receptacle. Each side of the GFCI duplex is
rated at 15 amps but the maximum total current from
the GFCI duplex is limited to 20 amps.
Undercarriage (K882-2) - 2- wheeled, hand moving.
Friction Pad Kit (K935-1) - Four rubber isolators that
attach to the bottom of the tube frame to prevent
movement on smooth surfaces.
Rotor Removal Kit (S20925) – A service kit with thru
and impact bolts for removing the generator rotor
from the tapered engine crankshaft.
BRIGGS AND STRATTON ACCESSORIES
(FOR THE 8 HP INTEK ENGINE ONLY)
The following options/accessories are available for
your POWER-ARC 4000 from your local Briggs &
Stratton Distributor.
Foam Pre-cleaner (B&S No. 493537) - Provides a
foam pre-cleaner for placement around the paper
cartridge air cleaner. Increases protection in extreme-
ly dusty or dirty environments.
Spark Arrester (B&S No. 399541) - The spark
arrestor attaches to the muffler to reduce the chance
of sparks being emitted from the muffler.
Muffler Guard (B&S No. 695386) - This guard installs
onto the muffler via supplied hardware and protects
against incidental contact with a “HOT” muffler.
SEMIAUTOMATIC MIG WELDING
WITH A LINCOLN WELD-PAK 100
OR WELD-PAK 125
In addition to using the accessories/options listed
above, the POWER-ARC 4000 generator can supply
power to a Lincoln ELectric Weld-Pak 100 or Weld-
Pak 125 wire feed welder. The Weld-Pak comes with
all the supplies needed for Flux-Cored Arc Welding
(FCAW).
A MIG (Metal Inert Gas) Conversion Kit is also avail-
able for the Weld-Pak. The kit provides everything
needed for Gas Metal Arc Welding (GMAW) or MIG
processes. Contact your local authorized Lincoln
representative for details about the Weld-Pak and
MIG Conversion Kit.
POWER-ARC 4000