Lincoln Electric IM879 RANGER GXT - Manual (Page 23)

C-2 ACCESSORIES C-2
RANGER GXT
RECOMMENDED EQUIPMENT
STICK
K704 Accessory Kit which includes:
• Electrode Holder & Cable
• Work Clamp & Cable
• Headshield
K875 Accessory Kit- 200 AMP
WIRE FEED
K449 LN-25 - Includes internal contactor for across
the arc operation (no control cable). Provides
“ cold ”
electrode until gun trigger is pressed. Includes gas
solenoid.
Magnum Gun and Magnum Gun Connector Kit are
required for gas-shielded welding. Innershield Gun is
required for gasless welding.
K126-2 Magnum 350 Innershield Gun
K1802-1 Magnum 300 MIG Gun (for LN-25)
K470-2 Magnum 300 MIG Gun (for LN-15)
K466-10 Connector Kit (for LN-15, K470-2)
K1500-1 Gun Receiver Bushing (for LN-15 & K126-2)
K1870-1 LN-15 Across the Arc Model
TIG
Magnum ™ TIG Torch
K1783-4 - TIG Torch
Magnum Parts Kit and Argon Gas
K930-2 TIG Module - Provides high frequency and shield-
ing gas control.for AC and DC GTAW (TIG) welding applica-
tions. Its compact case is designed foe easy carrying, com-
plete with a handle. High frequency bypass is built in
Requires K938-1 Contactor Kit, K936-3 Control Cable, and
K814 Arc Start Switch.
K938-1 Contactor Kit - For use with TIG Module, Provides a
“ cold ” electrode until the triggering device (Arc Start Switch)
is pressed.
K936-3 Control Cable - Connects TIG Module to RANGER
GXT.
Optional TIG Equipment:
K939-1 Docking Kit - For Mounting the K930-2 TIG Module
on top of the RANGER GXT.
K937-45 Control Cable Extension - Allows TIG Module to be
operated at distances up to 200ft. from the power source.
Available in 45ft. (13.7m).
K844-1 Water Valve Kit - For use with water cooled TIG
torch, Installs inside of TIG Module.
K963-3 Hand Amptrol
K870 Foot Amptrol
REMOTE OUTPUT CONTROL
(See Operations Section for reference)
The Ranger GXT is equipped with a 6-pin connector. The 6-
pin connector is for connecting the K857 or K857-1 Remote
Control (optional) or for TIG welding, the K870 Foot
Amptrol or the K963-3 Hand Amptrol. When remote con-
trol is used set the LOCAL / REMOTE switch in the
"REMOTE" position.
Plasma
K1580-1 Pro-Cut 55
(Requires Full KVA Adapter K1816-1)