Lincoln Electric IM813 RANGER 305 D (CE) - Manual (Page 14)

STACKING
RANGER 305D (CE) machines cannot be stacked.
ANGLE OF OPERATION
Engines are designed to run in the level condition which is
where the optimum performance is achieved. The maxi-
mum angle of continuous operation is 20 degrees in all
directions, 35 degrees Intermittent (less than 10 minutes
continuous) in all directions. If the engine is to be operated
at an angle, provisions must be made for checking and
maintaining the oil level at the normal (FULL) oil capacity in
the crankcase.
When operating the welder at an angle, the effective fuel
capacity will be slightly less than the specified 45 liters (12
gallons).
LIFTING
The machine weighs approximately 374 kg. (824 lbs) with a
full tank of fuel. A lift bail is mounted to the machine and
should always be used when lifting the machine.
HIGH ALTITUDE OPERATION
At higher altitudes, output derating may be necessary. For
maximum rating, derate the machine 2.5% to 3.5% for every
305m (1000ft.). Due to new EPA and other local emissions
regulations, modifications to the engine for high altitude are
restricted within the United States and some European
Countries. Use above 1828m (6000 ft.) may be limited due
to poor engine performance or excessive exhaust smoke.
An authorized Kubota engine field service shop should be
contacted to determine if any adjustments can be made for
operation in higher elevations locally.
HIGH TEMPERATURE OPERATION
At temperatures above 40°C, output derating is necessary.
For maximum output ratings, derate the welder output 2
volts for every 10°C above 40°C.
Cold weather starting:
With a fully charged battery and the proper oil, the engine
should start satisfactorily down to about 15°C (5°F). If the
engine must be frequently started at or below -5°C (23°F), it
may be desirable to install cold-starting aides. The use of
No. 1D diesel fuel is recommended in place of No. 2D at
temperatures below
-5°C (23°F). Allow the engine to warm up before applying a
load or switching to high idle.
Note: Extreme cold weather starting may require longer
glow plug operation.
Under no conditions should ether or other starting flu-
ids be used!
-------------------------------------------------------------------------------
WARNING
A-2 INSTALLATION A-2
SAFETY PRECAUTIONS
Only qualified personnel should install,
use, or service this equipment.
LOCATION AND VENTILATION
The welder should be located to provide an unrestricted flow
of clean, cool air to the cooling air inlets and to avoid restrict-
ing the cooling air outlets. Also, locate the welder so that the
engine exhaust fumes are properly vented to an outside
area.
ADDITIONAL SAFETY PRECAUTIONS
• Lift only with equipment of ade-
quate lifting capacity.
• Be sure machine is stable when lift-
ing.
• Do not lift this machine using lift
bail if it is equipped with a heavy
accessory such as trailer or gas
cylinder.
FALLING • Do not lift machine if lift bail is
EQUIPMENT can damaged.
cause injury. • Do not operate machine while
suspended from lift bail.
--------------------------------------------------------------------------------
Do not attempt to use this equipment until you
have thoroughly read the engine manufacturer’s
manual supplied with your welder. It includes
important safety precautions, detailed engine
starting, operating and maintenance instructions,
and parts lists.
------------------------------------------------------------------------
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or
electrode with skin or wet clothing.
• Insulate yourself from work and
ground
• Always wear dry insulating gloves.
------------------------------------------------------------------------
ENGINE EXHAUST can kill.
• Use in open, well ventilated areas or
vent exhaust outside.
------------------------------------------------------------------------
MOVING PARTS can injure.
• Do not operate with doors open or
guards off.
• Stop engine before servicing.
• Keep away from moving parts.
------------------------------------------------------------------------
See additional warning information at
front of this operator’s manual.
WARNING
WARNING
RANGER 305D (CE)