Lincoln Electric IM366 SP-100 - Manual (Page 8)

Type K462
Rated DC Output (For use on 20 ampere 90 amps @ 18 volts
branch circuit) 20% duty cycle
Maximum DC Output (For use on 25
ampere branch circuit with optional
100 amps @ 17 volts
K467 input line cord installed) 30% duty cycle
CSA Rated DC Output 63 amps @ 20 volts
(For use on 15 ampere branch circuit) 20% duty cycle
Input Power @ CSA rated Output 115 volts
AC only 60 hertz
15 amps
Maximum Open Circuit Voltage 28 volts
115 volts
Input Power @ Rated Output, AC only 60 hertz
20 amps
115 volts
Input Power @ 60 hertz
Maximum Output, AC only 25 amps
Wire Speed Range 50 to 400 in./min
(1.3 to 10.2 m/min)
Wire Sizes .023 – .030" (0.6 – 0.8 mm) Solid Steel
.035" (0.9 mm) Flux-Cored (1)
Spool Sizes 8" OD x 2" ID x 2.2" wide
(200 mm x 50 mm x 56 mm)
4" OD x 5/8" ID x 1.7" wide
(100 mm x 16 mm x 43 mm)
Weight 54 lbs (24.3 kg)
Dimensions (H x W x D) (Less Handle) 12" x 9 3/4" x 16 1/2"
(305 mm x 248 mm x 419 mm)
SPECIFICATIONS
1) Requires optional Innershield Welding Kit
INSTALLATION
– 8 –
SAFETY PRECAUTIONS
● Read the safety precautions at the beginning of
this Operator's Manual before proceeding.
● Only personnel that have read and under-
s t o o d t h e SP-100 Operating Manual should
install and operate this equipment.
● Machine must be plugged into a receptacle which
is grounded per any national, local or other applic-
able electrical codes.
● The SP-100 power switch is to be in the OFF
(“O”) position when installing work cable and gun
and when connecting power cord to input power.
UNPACKING THE SP-100 (K462)
Unpack the SP-100 from its carton and remove all
packing material around the SP-100. Remove the fol-
lowing loose items from the carton:
1.SP-100.
2.Gun and cable assembly
(1) — ready to feed .025"
(0.6 mm) diameter wire (also .023 and .024 diam-
eter wire).
3.Literature envelope which contains:
a) This operating manual, and
b) A contact tip for .030" (0.8 mm) diameter wire.
4.10 ft (3.0 m) work cable.
5.Work clamp.
(1) K474 model gun is ready to feed .035 (0.9 mm) Innershield
with conversion parts for .030 (0.8) wire.