Asus Striker Extreme - Manual (Page 58)

2-32 Chapter 2: Hardware information
Connect the right-angle side of SATA
signal cable to the SATA device, or
connect the right-angle side of the
SATA cable to the onboard SATA port
to avoid mechanical conflict with huge
graphics cards.
Right-angle side
4. USB connectors (10-1 pin USB56, USB78, USB910)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
You can connect the USB cable to ASUS Q-Connector (USB, blue) first, and
then install the Q-Connector (USB) to the USB connector onboard.
STRIKER EXTREME
®
STRIKER EXTREME
USB 2.0 connectors
USB56
NC
GND
USB_P6+ USB_P6- USB+5V
GND USB_P5+ USB_P5- USB+5V 1
USB78
NC
GND
USB_P8+ USB_P8- USB+5V
GND USB_P7+ USB_P7- USB+5V 1
USB910
1
NC
GND
USB_P6+ USB_P6- USB+5V
GND USB_P5+ USB_P5- USB+5V