Lincoln Electric IM680 Power Wave Water Cooler - Manual (Page 9)

A-2 INSTALLATION A-2
4. The Power Wave 455 weights 300 pounds. Use a
suitable overhead crane or equivalent lifting device
to safely raise the Power Wave 455 by its lift bale.
Place temporary supports (4 x 4 in Lumber) across
the cooler at points shown to support the power
source. Lower the Power Wave 455 onto temporary
supports. Do not remove overhead crane.
5. Connect the circular connector at the rear of the
water cooler to the connector at the rear of the
power source.
6. Remove temporary supports and carefully finish
lowering the power source onto the water cooler
and line up the mounting holes in the channels at
the base of the power source.
7. Using the four 3/8 screws provided, fasten the water
cooler to the power source.
8. Connect the two front leads from step 3 to the termi-
nal strip at the front of the power source.
POWER WAVE WATER COOLER
SAFETY PRECAUTIONS:
ELECTRIC SHOCK Can Kill
• Only qualified persons should perform
this installation.
HOT COOLANT CAN BURN SKIN
• Always be sure coolant is not hot
before doing any work on cooler
parts.
R O TAT I N G F A N B L A D E S A R E
HAZARDOUS
• Do not put your hands near an operat-
ing fan.
• Keep all equipment safety guards, covers and
devices in position and in good repair. Keep
hands, hair, clothing and tools away from fans
and all other moving parts when starting, operat-
ing or repairing equipment.
• In some cases it may be necessary to remove
safety guards to perform required maintenance.
Remove guards only when necessary and
replace them when the maintenance requiring
their removal is complete. Always use the great-
est care when working near moving parts.
------------------------------------------------------------------------
ATTACHING THE WATER COOLER TO
THE POWER SOURCE:
1. Preparation:
• Always turn off the power to the water cooler
and to the power source before servicing the
machine.
• Always disconnect the Power Wave machine
from its service input power before servicing the
machine.
2. Detach all shipping material from the water cooler.
3. Make sure the wiring bundle with two leads in it is
routed toward the front of the water cooler through
the 1” diameter opening in the sheet metal (see
Figure 1).
WARNING
FIGURE 1
WARNING
WATER COOLER
CIRCULAR
CONNECTOR
(STEP 5)
TEMPORARY
SUPPORT
POINTS
1.00” HOLE FOR
WIRING BUNDLE
(STEP 3)
SCREWS (4)
(STEP 7)
POWER WAVE 455