Antec NINE HUNDRED TWO V3 - Manual (Page 9)

8
Pin Signal Names Pin Signal Names
1 USB Power 1 2 USB Power 2
3 Negative Signal 1 4 Negative Signal 2
5 Positive Signal 1 6 Positive Signal 2
7 Ground 1 8 Ground 2
9 Key (No Connection) 10 Empty Pin
2.10 Water Cooling Platform
This case comes with a 5.25” metal plate pre-installed in the 3rd 5.25” drive bay. This plate is designed
to allow you to easily mount components of a water-cooling kit such as a pump or reservoir. The plate
can be mounted in any of the nine 5.25” drive bays for maximum flexibility.
Note : The plate is not pre-drilled. You will need to drill the appropriate holes to be compatible with
your water-cooling kit.
2.11 Three-Way SLI Configuration Option
The Nine Hundred Two V3 has eight expansion slots, making it capable of supporting up to three
graphics cards in triple-SLI configuration. Consult your motherboard and graphics cards manuals for
more information.
Connecting the Front I/O Ports
3.1 USB 2.0
Connect the front I/O panel USB cable to the USB header pin on your motherboard. Check the
motherboard manual to ensure that it matches the table below:
3.2 USB 3.0
There is a pre-routed cable for the front-panel USB 3.0 port. Plug the back end of this cable into an on-
board USB 3.0 port on your motherboard to enable the front USB 3.0 port.
1 2
9 10