LT Security PTZKB636 - Manual (Page 3)

User Manual of System Keyboard
- 4 / 21 -
SHIFT—shift key
CLOSE—close lens iris (IRIS-)
OPEN— open lens iris (IRIS+)
FAR— regulate focus (FOCUS-)
NEAR—regulate focus (FOCUS+)
TELE— feature picture (ZOOM-)
WIDE— panorama (ZOOM+)
LIGHT—lighting control
WIPER—brush control
PATRN—image tour
LOCK—soft lock
MENU—menu programming
C— digital removal key
UNIVERSAL ZONE – control tilt direction
FIGURE ZONE – used for entering figures
Note: figures can be removed if
0 key is pressed for a little longer.
When a figure exceeds four places, the keyboard can reset automatically, and
display a new figure.
User Manual of System Keyboard
- 5 / 21 -
Using the code switch at the front of the keyboard, set a keyboard code (see
Part 3). Provide power with a DC 12V power source through an interface box
and an eight-core flat wire, and connect the interface box to the
communication interface of the matrix mainframe properly. After power on,
the communication indicator (CODE) flickers (if it does not flicker, the
interface box is misconnected). Indication of “LOCK” in the status display
area requires to enter a 4-place keyboard password (the original password is
“0000”) as follows:
LOCK + “****”+
OFF . After inputting a password
correctly, “----”will appear in the status display area. After entering a
monitor number and pressing the confirmation key MON , the monitor display
area indicates the currently controlled monitor number, demonstrating that the
keyboard is under control.
1.2 Locking keyboard operation
After keyboard operation, to prevent illegal operation, keep the
keyboard in a protective condition in the following way:
1.Press LOCK key;
2.Press ON key; “
LOCK
”will be shown on the status display
area.
1.3 Unlocking keyboard operation：
： ： ：
Unlocking keyboard operation protection
Method
： LOCK + “****”+ OFF ，where **** is a 4-place keyboard
password (the original password is “0000”).
1.4 Keyboard password setting： ： ： ：
A keyboard password is a 4-place figure. To change a password
1. Have the lock switch on “ PROG ”position;
Part 1 Switching System of Control Matrix
1.1 Keyboard power-on:
DISPLAY
MO N: 001 CA M: 000 1
NE T: 000 AR M: 000 0
<LOCK> <LOCK> <LOCK> <LOCK>