LT Security IPPTZ762 - Manual (Page 43)

User Manual of IR Network Speed Dome 42
To enter the Time Settings interface:
Configuration > Basic Configuration > System > Time Settings
Or Configuration > Advanced Configuration > System > Time Settings
Figure 6-2 Time Settings
 Configuring Time Synchronization by NTP Server
Steps:
(1) Check the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server.
It can be set from 1 to 10080 minutes.
Figure 6-3 Time Sync by NTP Server
If the speed dome is connected to a public network, you should use a NTP server
that has a time synchronization function, such as the server at the National Time Center (IP
Address: 210.72.145.44). If the speed dome is set in a customized network, NTP software
can be used to establish a NTP server for time synchronization.