RIKON Power Tools 20-110 - Manual (Page 6)

6
Loose Parts in Loose Bag 2
3 3/8” Flat Washers
3 3/8” Lock Washers
3 Mounting Bolts
1 3mm Hex Wrench
1 5mm Hex Wrench
1 8/10mm Open End Wrench
1 12/14mm Open End Wrench
Tools Required for Assembly
Philips Head Screwdriver, Adjustable Wrench, 14mm Open End Wrench and a metric socket set.
1. Carefully remove all contents from both shipping cartons. Compare contents of the shipping
cartons with the list of contents in this manual. Place parts on a protected surface.
2. Report any shipping damage to your local distributor.
3. Clean all rust protected surfaces (bed, fence, etc.) with a parts cleaning solvent or WD40.
Do not use; gasoline, paint thinner, mineral spirits, etc. as these may damage painted surfaces.
Caution: Cutterhead blades are extremely sharp! Use care when cleaning!
4. Apply a thin layer of paste wax to the milled surfaces of the fence and tables to prevent rust.
5. Set packing material and shipping cartons to the side. Do not discard until machine has been
set up and is running properly.
4 Hex Head Screw M8
4 Hex Nut M8
2 1/8” Flat Washers
6 1/8”x3/8” Pan Head Screws
1 Blade Lock Tool
1 Blade Adjust Tool
Unpacking Carton and Cleaning