RIKON Power Tools 20-100 - Manual (Page 12)

12
Figure 15
Figure 16
45º Fence Adjustment
1. Loosen lock handle (A-Fig. 16). Move the
stop plate (F-Fig. 16) out of the way and
position the fence at the 45
º
angle. Make
sure the fence sits against the stop bolt (G-
Fig. 16).
2. Place a combination square on the fence and
table to confirm a 45
º
angle setting.
(A-Fig. 17)
3. To adjust, loosen lock nut and bolt (G-Fig. 16),
until a 45
º
angle is obtained, and tighten lock
nut (G-Fig. 16).
4. Tighten lock handle (A, Figure 16).
4. Place a combination square on the in-feed
table to check that the fence is 90
º
to the
table. (A-Fig. 15)
5. If fence is not square to table, release lock
handle (A-Fig. 16) and adjust using handle
(C-Fig. 16) until the fence is 90
º.
6. Now that the fence is 90
º
to the table, adjust
the positive stop screw assembly (E-Fig. 16)
to maintain the 90
º
position.
7. Retighten lock handle (A-Fig. 16).
Figure 17
Adjustments
A
E G
A
B
C F
A