SHARKOON Scorpio 2000 - Manual (Page 9)

scorpio 1000/2000
5. Place the mainboard back onto the stand-offs and screw the
mainboard to them (fig. 4).
(Screws for mainboard mounting)
fig. 4
6. Plug the connectors of the case’s front bezel to the respective
connectors of the mainboard (also refer to your mainboard’s
manual for further information).
Note:
The eSATA cable connected to the front eSATA connection should
not exceed 50 cm of length otherwise transmission errors may
occur! With premium quality eSATA cables this maximum length
may be exceeded.
5. Installing a HDD
5.1 Fast Swap bays
1. Set up the case in front of you.
2. Open the bezel of the Fast Swap bays. Unlock one mounting
frame’s detent lever, pull the mounting frame towards you and
take it out of the case (fig. 5).
fig. 5
3. Place a 3.5" SATA HDD into the mounting frame (connectors
pointing backward/ fig. 6).
fig. 6