ShelterLogic 29522 10 x 20 Max AP Canopy - Manual (Page 4)

05_29522_0B Page 4
2. AsseMBle rooF FrAMe
NOTE: Swedged tubes insert into plain ends at the crimp marks.
3. AsseMBle leGs & AttAcH to rooF FrAMe
A. Attach all legs to one side first. Let the other side of roof frame rest on the
ground. Repeat for opposite side.
Leg Pole Assembly
4. AncHor tHe FrAMe
There are four holes on each base foot that the anchor can go into.
A . Select a hole in each base foot. Insert each anchor (10431) into the ground until the round head is touching the
base foot. These anchors prevent the canopy from shifting. Insert one anchor into all four base feet.
This is a temporary spike anchor. Not intended for permanent use.
B . To securely anchor canopy, Accessory Anchoring Kit #10073 is recommended. The 4-anchor pins are inserted
into the ground. Then the ropes are tied from the anchors to the corner tees as shown in B.
Tie Rope Around Frame Corners
802205
rope
802201
802204
B
802205
802203
802916
802203
802916
10431
Anchoring Base Feet
A
Swedged Tubes Connections
802203
Crimp Marks
802204