ShelterLogic 23572 10 x 20 Super Max Canopy 2-in-1 Pack - Enclosure Kit - Manual (Page 8)

05-23572-0B Page 8
9. TIGHTEN THE COvER WITH TWIST TITE ™
A. Wrap the cover's cord with plastic ball and "S" hook
at the corners of the cover around the corner leg poles.
Insert "S" hook into the hole of the corner leg poles.
Twist each leg pole toward the inside of the shelter until
the cover becomes tight. Twist the leg poles equally to
ensure the cover stays aligned during tightening.
B. To keep the leg in place, wrap a TwistTite™ cord
around the cross rail and insert its "S" hook into the
lined-up hole of the leg pole and 3-way connector.
This will prevent the leg from "untwisting". Do this at
each corner.
8. ATTACH ENCLOSURE WALL AND DOOR PANELS
Canopy enclosure panels attach to frame with bungee cords.
A. Attach all the enclosure panels with bungees at the top first. Adjust the panels as needed to ensure a tight
and even fit before securing to legs with bungees.
B. When securing enclosure panels to legs, note that each bungee is shared with the neighboring panel.
NOTE: Door panels zippers must be closed when securing door panel.
CAUTION: Bungee Cords are under extreme tension. Use Caution when installing. Safety glasses are
recommended to prevent injury.
Interior / Rear view of Canopy Enclosure Panels
Back Panel
10301
One bungee for
both panels.
Side Wall
Panel
10082
Twist-Tite ™ Tighten Cover
10043
10302
10045 B A