SnowEx PWX-250 - Manual (Page 15)

15 © Trynex International 2012 (REV A) F50766
Installation Instructions
Installing on the Spreader
Re-Install the Auger Extension Cover and the Spinner Drive Latch Pin.
Slide the Hose Assembly onto the Barbs just installed. The 9” Hose should go to the Barb closer to the Hopper. Use
the Small Plastic Hose Clamps [F50145] to tighten.
Connect the Hose Assembly to the Pump on the outlet side. Clamp with clip on the pump.
Step 15:
Step 17:
Step 16:
Channellocks...
Installation Finished...