SnowEx SP-100 - Manual (Page 15)

15 © Trynex International 2012 (REV 001)
Troubleshooting
Model # SP-100
Snowex Diagnostic Test Kit (STK-080) Is Available To Accurately Diagnose Any Issues With Snowex Spreaders.
Call Your Dealer For Details.
Spreader Doesn’t Run
Material Will Not Flow
Fuse Blown
Electrial Connection
Check Battery
Gate Won’t Open
Material Issue
Jammed Agitator
Test Direct Power
(12 Volts) To Motor
Load Test
Check Switch
Reconnect Or Replace
Cable
Too Much Amp Draw
Loose Or Unplugged
Dead Short In Wiring
Corrosion
Agitator Interference
Bad Motor Check With
Test Kit
Bad Electrial
Connection
Bad Motor/Trans
Assembly
Material Issue
Replace Wiring
Fix or Replace
Bad Transmission
Check With Test Kit
Corrosion At
Connection
Bad Motor Check With
Test Kit
Loose Connection
Test Turn Shaft By
Hand Should Turn
Freely
Clean Or Replace
Test 4 to 20 Amp Draw
No Load Good
Tighten Or Replace
20 + Amp Draw
No Load Bad
Don’t Forget Use
Dielectric Grease
Don’t Forget Use
Dielectric Grease