SnowEx Junior 325 - Manual (Page 25)

SPREADER ASSEMBLY (575 Shown)
© Trynex International 2009 L1040 7 — 25
Adjustable Deflector Installation Instructions
Model #ADF-020 For SP-575 and SP-1075
INSTALLATION
Step 1: Install deflector adjustment bar as seen in Figure A. If needed, drill two 3/8” holes in front apron of drive enclosure.
Bolt bracket to drive enclosure.
Step 2: Remove original deflector.
Step 3: Mount adjustment bar and mounting bracket on back side of 36” deflector. See Figure B.
Step 4: Install 36” deflector assembly.
OPERATION
Step A: To adjust deflector position, simply insert adjustment bars into holes on deflector adjustment bracket until desired
spread pattern is achieved.