SnowEx VBR-400 - Manual (Page 3)

© TrynEx International 2013 (REV A) F50853 3
Installation Instructions
Model # VBR-400
STEP 1
Remove the Nut from the Inverted-V on the Front, Passenger-
Side Corner.
WEAR EYE PROTECTION.
Installing the Vibrator
STEP 2
Inside the Hopper...
Grind the welds off the Weld-Stud. Once the welds are ground off, the Weld-
Stud can be removed from the Inverted-V.
STEP 3
If desired, prime and re-paint where the powder-coat has been removed by
the grinder.
STEP 4
Set the Vibrator on top of the Inverted-V to use as a template for drilling the
mouting holes in the hopper. Drill the four mounting holes with a 3/8” bit.