SnowEx SP-9300 - Manual (Page 28)

L1218 © Trynex International 2009 MAX — 28
Operating the Spreader
(continued)
BAFFLE INSTRUCTIONS
t The V-Maxx SP-9300 uses a dual baffle design over the auger area.
This baffle (D6889) is used for dry bulk materials. The baffle is
designed to reduce the risk of leakage with clean/dry free-flowing
materials. If the material you are using is damp/wet, you may need
to remove baffle (D6889). This will allow for more un-restricted flow
of materials and possible bridging.
t WARNING: Always disconnect power source before attempting to
remove material baffle.
t The main baffle assembly (D6889) must NEVER be removed from
its original factory installed position unless the unit is being serviced
or installing Optiflow Kit.
D6889
Model # SP-9300