SnowEx SP-9800X - Manual (Page 11)

11 © TrynEx International 2012 (REV B) F50735
Operating Spreader
Model # SP-9800X
INVERTED-V INSTRUCTIONS
• The Super-Maxx 9800 uses an inverted-v design over the auger
area. This inverted-v (F50375) is used to reduce load to the auger
drive train. It must not be removed unless servicing the unit.
• WARNING: Always disconnect power source before attempting to
remove material baffle.
F50375
Auger Discharge Tube
AUGER DISCHARGE TUBE INSTRUCTIONS
• The Super-Maxx Spreaders use an auger discharge tube to reduce
material leakage. It must not be removed unless servicing the unit.
• WARNING: Always disconnect power source before attempting to
remove auger discharge tube.