Spectra Precision FAST Survey - Manual (Page 29)

Engl
ish
21
Configuring a Rover
The following Spectra Precision GNSS receivers may be used
as a rover: ProMark 700, ProMark 800, EPOCH 50, ProFlex
800 or ProMark 220.
Prerequisites For ProMark 220:
• If you are using the internal GSM modem, insert the SIM
card making possible the use of the modem.
• If you are using an external radio, connect that radio to the
receiver using a POGO cable (see Using an External Radio
with a ProMark 220 on page 53).
• Connect the external antenna to the receiver
• Power on the receiver, run FAST Survey and open a job
file.
• Set the tracking mode using GNSS Toolbox. FAST Survey
will only be able to work from the signals selected with this
utility.
– Assuming ProMark 220 is the currently selected GNSS
receiver in FAST Survey (Current tab), running GNSS
Toolbox from within FAST Survey is simply done by
selecting
Equip > GPS Utilities > GNSS Toolbox > GNSS
Settings.
– Select the desired option from the Tracking mode drop-
down list. You can also set the elevation mask, enable
or disable the use of SBAS and QZSS and preset the
model of external antenna used.
– Then tap
OK twice to return to the Equip menu.
For all other receivers:
• If you are using a GSM modem (whether internal or
external), insert the SIM card making possible the use of
the modem.
• If you are using an external radio receiver, connect that
radio to the receiver and turn it on.
• Make sure an external GNSS antenna is connected
(ProFlex 800).
• Power on the GNSS receiver and data collector.
• Run FAST Survey and open a job file.