Spectra Precision Survey Pro v4.5 Recon and Nomad User Manual - Manual (Page 363)

Basic GPS Module
353
3. Fill in the screen and tap Next>. The base point name and
the precise geodetic coordinate of the base are noted in Survey
Pro. If you are doing post processing at the base, the station
name, description, and antenna height are then sent to the
file on the base receiver for post processing.
Set Up Rover
4. You are prompted to connect to the rover receiver
or will be automatically connected if using
Bluetooth. Once you connect to the rover, it will
begin to monitor the data link for the base
corrections. You are then prompted to enter the
rover antenna height to proceed with the setup.
The button at the bottom right of the screen will
say Next > any time this is a remote rover setup,
or if you have set the base but the projection is
not fully set and solved for this survey. The
button will say Finish if you have set the base and
the projection is solved.
a. On Next >:
i. If the base was not set with this wizard, takes
you to Setup Remote Base screen (Page 355).
ii. If the base was set with this wizard, writes
the base and rover setup raw data, and takes
you to Solve Projection routine (Page 356).
b. On Finish: Writes the base and rover setup raw data,
sets the rover receiver and exits.