Installation of jumbo j1842a cabinet – Tennsco J2442A User Manual

Page 2

Advertising
background image

Tools needed: An

11

/

32

" nut driver (provided free with unit); a hammer; and a flathead screwdriver.

Two people recommended for installation. Approximate assembly time: 15 to 25 minutes.

INSTALLATION OF JUMBO J1842A CABINET

1.

The reference numbers used throughout this
sheet refer to the illustration on the back cover.

This is to help you to identify the various parts as

they are mentioned.

2.

Place the two pieces of the cabinet back (Ref. No. 1 )

side by side on a protected surface to prevent

scratching the paint. The

flanges should be

facing upward. Overlap

the right panel

over the left

panel.

After align-

ing the holes,

bolt the two panels

tightly together with four

bolts and nuts.

4.

Attach the right side (Ref. No. 3) to the back in

the same

manner as you did in step 3, again

making sure that the flange is

around the back and that the

lances on the shelf adjustment

strips are pointed in the

s a m e

direction as

those on the

the back

and left side.

Flanges

face

upward

on

both

halves

3.

Attach the left side (Ref.

No. 2) to the back by

placing flange (A)

around the back

and bolting the

back and side to-

gether with four

bolts and nuts (Ref.

Nos. 19 & 20). Be sure

that the lances on all shelf

adjustment strips (B) point in

the same direction.

Flange goes

under back

B

A

All

lances

point

UP

on

both

backs

and

side.

5.

Insert two bolts into the outside holes on each end

of the sill (Ref. No. 4). Attach the nuts, but do not

tighten. Place the sill between

the sides at the front of

the cabinet, in-

serting the loose

bolt heads into

the two keyhole

slots on each

side. Make sure

the bolt heads are

fully pushed up into

the bottom of the keyhole

slots, as shown at right. Securely

tighten the four bolt heads.

6.

Place the header (Ref. No. 5) at the top of the

unit and attach by inserting

two nuts and two bolts

through the holes at

each end

7.

Place a shelf (Ref. No.

6) into the bottom

lances, located on the

back and sides of the

unit. The flange on

the sill will be just in

front of the shelf.

Right side

overlaps

the left

Bolt heads

insert into

keyhole

slots

Properly

inserted

Improperly

inserted

Insert shelf into

the bottom notches

on back AND sides.

8.

Set the unit upright and insert

the remaining shelf at

the desired level. Be

sure that the edge with

no slots is toward the

cabinet front. (The slots

on the other three

sides will fit over

the lances on the

cabinet walls, which hold

the shelf in place.) Make sure

the rear of the shelf is seated into

all four lances.

Inset A

Advertising
This manual is related to the following products: